SirMoh
New Member
- Total Posts : 19
- Reward points : 0
- Joined: 2016/09/21 06:09:08
- Status: offline
- Ribbons : 0
Hello, I was experimenting whether or not I could get a better overclock with my 1070 FTW on the Slave BIOS as it allows a higher power limit. Alas, this was not the case, so I switched back to the Master BIOS.However, now the fans run at 20% speed regardless of what I set the fan curve to using EVGA Precision XOC. Previously the fans would not run at all, up until I switched to the Slave BIOS (where I'm aware the fans will always run at 20% minimum speed) and then switched back to the Master BIOS. I've power cycled my computer, taken the card out and put it back in, but the fans still run at 20% minimum speed regardless. GPU-Z shows the correct BIOS being selected: 86.04.26.00.70 Is there anyway to fix this? UPDATE: Ran DDU and installed the drivers fresh, seems to have fixed it. Topic can be closed.
post edited by SirMoh - 2016/09/24 08:34:01
|
