I am looking to sleeve my cables for my PSU. I've done some searching on this forum and elsewhere, and come up with some conflicting results. I haven't found any results specifically for this model either. Mainly I am looking for the pinouts for the 24 Pin and the PCIE cables. I have seen that the 24 pin, is 1:1 to either end of the cable, with some wires crossed but still going to correct voltage/ground points, can anyone confirm this? Also, I was curious as to if the PCIE cables are 1:1 as well, as I have found NO info regarding that. I have disassembled the two extra cables that i am not using currently to do a makeshift pinout, but they were both completely different. So I assume it is just 1:1 with random wires crossed, but terminating in their respective voltage/ground points, can anyone confirm that as well? Thank you!

So, from what I understand both ends of the cables follow the industry standard, or the motherboard end of the 24 pin should be the same as the PSU end?
 
I can go pin 1 on the psu end to pin 1 on the motherboard end, and repeat for all pins?
 
That seems to be the way that the PCIE cables are (after checking the component end charts and checking continuity), so i just would like to make sure it would be the same for the 24 pin (I just dont want to tear my rig apart to check until the supplies come in).

Okay, I pulled the 24 pin out of my case, and ran some continuity tests. This is the pinout I am left with, so my suspicions are correct, there were some wires crossed, some wires lead to different pins at the other end, but they terminate at the same voltage/ground etc points at each end.