wow is that oced what is the stock heat like.

all right get it colder crew I decided to sack up and go the bong cooler route after seeing nates results the water chiller is just too much money just a few questions for nate. What sort of pump do you have do you think a mcp655 will do the trick if not what do you suggest. Since your temps dont go below ambient there is no need for moister control right, and I can keep my rad in the line that will not hurt will it dosent really matter either way I suppose.

Yea those are great temps im willing to bet thats like two degrees over ambient Ill load up defaults and get back to ya.

reggiesanchez

ya I get 32 idle and around 50 load with all stock settings so id say those are pretty dam good have you tried to see how the bong handles voltage

NICE!  so bong cooler works!  but also realize that I have a few pounds of pure copper involved in my CPU block.  Yes, POUNDS of copper involved in it

But I forgot to ask, what is your cooler that you are using now that gets your 32°C at idle?

Never mind, I just looked at your mods rigs page,  a Zaleman air cooled. 

what about this pump ill pull the trigger on it if someone can point me in the direction of reducers for the outlet\inlet

Just ordered a Classy e760 from here, and was able to use my 99 EVGA bucks on it. Woohoo!

Also, i think i found my ram: http://www.frys.com/product/6057188?site=sr:SEARCH:MAIN_RSLT_PG
Ignore the picture, it is wrong. They are actually the tall heatsink ones; this is the exact same kit: http://www.newegg.com/Product/NewProduct.aspx?Item=N82E16820104132&cm_re=kingston_ddr3_2000_6gb-_-20-104-132-_-Product

Kingtson DDR3 2000mhz 9-9-9 1.65v. Only $170! I found a great deal on them. They are $200 at the egg.

I can't wait to get all my stuff!
 
EDIT: Dangit, the ram is out of stock at my local Fry's...now what?
EDIT 2: I just called my local TigerDriect. They will pricematch Fry's on the ram!

I feel all depressed and left out...everybody's building something here  Ok..I just put some stickers on my case..I feel a little better now

nope, its just a hair smaller then 1/2".  in some cases it works really well because of the tight fit on the 1/2" connectors.  Harder to get on the fittings, but when you do, in most cases you don't need clamps the fit is so tight (id use clamps if your still not comfortable with it)

Q56_Monster

I feel all depressed and left out...everybody's building something here  Ok..I just put some stickers on my case..I feel a little better now

LOLOL!!!

that's G ic2 there mr up early in the morning...lol

that's because i can't get my cpu back to where it needs to be..4.7ghz

my block is actaully working pretty damn good now.
and now that pj isn't a problem anymore. things are looking up!
i did get a few test runs in at 4.6 ghz, but still a bit shakey...

so it was a bust?

that's all bad....

that's what i was doing before...used 2 radiators and ran the system...then would turn the chiller on for serious benching.
now i just run the chiller..lol