Hi- does anyone know how to turn off the red EVGA logo on the GTX780ti classified hydrocopper cards as the red led's ruin the look of my black and white theme
I've tried the Geforce Experience thingy no use

I'm not going to put tape over it which will make my rig look awful and not really liking the idea of removing the waterblock to both cards but if that is the only way then I'll suppose I'll have to do it
Shame there isn't a software method- bios or something to do this

There is a fan cable that the acx cooler would normally use for the fans plugged into a 3 pin connector directly below the 8 pin power connectors. It powers the led. If you unplug it the led will turn off.

http://www.legitreviews.com/wp-content/uploads/2013/11/NVIDIA_GeForce_GTX_780Ti_PCB-3qtr.jpg

It is on the PCI side of the card. In the above picture, it will be the connector in the top right side next to the capacitor. You may be able to see it without removing the block.

http://international.down...pper-watercooler-2.png

Looking at the spacing in this picture, it looks like there will be enough clearance to use a jewelers screwdriver or something like it, maybe even a tooth pick so it isn't metal, to disconnect it. I used a screw driver to check the connections on my 750ti, and that fan header is smaller than the one on the 780ti.

Thank Anarchy for thinking of it, not me. :-)

Thanks for the headsup- I now have a lovely SLI rig with no red leds at all

only issue now is that my gpu temps have jumped from 29 +30c to 48 + 56c- not sure what the deal is with that so must investigate!!

the loop looks fine but my pumps did start sounding like a cement mixer for a while- just hope it's air blockage but if no better tomorrow I will redo the loop
I'll post some pics as well if I get it sorted

Scarlet-Tech
:-) good deal. I would love to have the logos that light up, and a sleeve type film (see gel filters for a camera) that could change out to make them white leds with a choice to change color anytime.

I did change the led's to white and use colored film under the metal EVGA cover on my HC Titans.  The red really clashed with my system.  Used colored film on the Pro SLI bridge as well, led is already white.  

Spoke too soon- gpu back up to 48 + 40c- not sure what to do now!

My gpu pump has died as it does not spin at all- I've tried 2 different psu and nothing at all so those noises were the pump dying so I've ordered a new one and should be here Thursday or Friday I hope

Thanks scarlet just a waiting game now

Please take pictures, because it sounds like something else is going on at this point.  I am not sure what motherboard you are using.  If it has dipswitches, make sure they didn't get bumped into the off position by accident.  Make sure your cables, even on the power supply, are fully seated as well.   

Sorry man. Definitely look into an RMA.

Hopefully so.  Sorry for all of the frustrations.