EVGA

EVGA GTX 680 Hydro copper water block

Author
Post
Essentials Only Full Version
lamechw
New Member
  • Total Posts : 12
  • Reward points : 0
  • Joined: 2012/05/02 06:51:53
  • Status: offline
  • Ribbons : 0
2013/07/26 08:05:34 (permalink)
When I clean up the water block, i discover the thermal pad was damage. How many the thickness of the thermal pads for the EVGA GTX 680 Hydro copper. I need to know the thickness to buy suitable thermal pad to replace.
#1

4 Replies Related Threads
    JoeyC
    EVGA Alumni
    • Total Posts : 1703
    • Reward points : 0
    • Joined: 2012/02/22 09:56:36
    • Location: EVGA Brea
    • Status: offline
    • Ribbons : 4
    Re:EVGA GTX 680 Hydro copper water block 2013/07/26 08:17:28 (permalink)
    The thickness used is 0.5mm. http://www.evga.com/support/faq/afmmain.aspx?faqid=58590
     
    Hope this helps 

    Rate my service by going to: http://www.evga.com/myevga/rateus/

    #2
    lamechw
    New Member
    • Total Posts : 12
    • Reward points : 0
    • Joined: 2012/05/02 06:51:53
    • Status: offline
    • Ribbons : 0
    Re:EVGA GTX 680 Hydro copper water block 2013/07/26 08:30:42 (permalink)
    thx for your helpful info, another question, how many the thickness for the blackplate's thermal pad, is that 1mm?
    #3
    wpinch
    New Member
    • Total Posts : 60
    • Reward points : 0
    • Joined: 2013/04/12 05:05:54
    • Status: offline
    • Ribbons : 0
    Re:EVGA GTX 680 Hydro copper water block 2013/07/26 15:19:02 (permalink)
    Thanks for this info also , will help if i need to replace thermal pads on my hydro copper blocks
    #4
    ollien33
    New Member
    • Total Posts : 1
    • Reward points : 0
    • Joined: 2012/04/15 02:19:25
    • Status: offline
    • Ribbons : 0
    Re:EVGA GTX 680 Hydro copper water block 2014/07/29 02:45:46 (permalink)
    Hello  - a bit of a thread resurrection, but I am experiencing the same issues. But with the GTX680 Classified, there appears to be a few different thicknesses in the thermal pads, especially on the back plate.
     
    Is it possible to buy a set of thermal pads? I have two 680 Classifieds sitting here, naked with no cooler waiting for the hydro copper blocks to be fitted - it's a very sad sight!
     
    Any help would be much appreciated.
     
    Ollien33
    #5
    Jump to:
  • Back to Mobile